What does this actually mean?
Well, first it means that the American Death Triangle is really bad...
And second it means that...
If an anchor is composed of two pieces, and one piece is directly above the other piece, and you are using a pre-equalized knot on a cordellete clipped to the pieces, then you are likely to be close to completely equalized at your master-point. The photo below shows a three piece anchor with low angles between the pieces. The low angles make this a very good anchor. However, due to the fact that the pieces are not completely in line with one another, the anchor cannot be truly equalized.
A Very Good Pre-Equalized Anchor that is Not Truly EqualizedGuides believe that this is an acceptable anchor.
Photo from Splitter Climbing Gear
When the angle on a two-point anchor increases, so too does the load on each piece. The theory is that when there is no or a very low angle -- under 20 degrees -- the pieces are close to equalized. When the angle increases to 40 degrees, then 54% of the load is on each piece. As the angle increases to 80 degrees, then 70% of the load is on each piece. And when the angle increases to 120 degrees, then 100% of the load is on each piece.
The following chart from the Technical Manual for Mountain Guides from the AMGA, demonstrates this with proposed weight of 1000 pounds.
The video savvy Canadian guide, Mike Barter, put together a great video on this subject for youtube.com. He uses a number of visual demonstrations throughout the video to show how weight affects an anchor as the angle increases. Check out the video below:
--Jason D. Martin
NOTE:
This is the second time we've posted this blog. And after I posted it the first time a couple of years ago an extremely valid comment was made. I thought that it would be prudent to post the comment as well as my response:
I hate to flame people trying to put good information out for the public, but I thought his demonstration was pretty silly. First off(although it really wasn't important for the demonstration) he had the knot of the cordelette directly on the carabiner of one of his "anchors". You think that an IFMGA guide wouldn't do this even in a demonstration. His demonstration really didn't show the increase in force on the anchor, but the change in the direction of pull. I think he could of easily done this by attaching a simple fish scale to each anchor.
I also thought about the knot on the carabiner when I found this video. The knot on the carabiner does weaken the cordellete mildly.
I have seen A LOT of IFMGA guides do this over the years. Indeed, I've seen enough of them do this that I've considered pulling back on the amount of emphasis I've put on keeping the knot out of the carabiner in the classes that I teach.
In addition to this, lets remember what this blog is about. It's about how angle impacts individual pieces...and I think that the video does a great job of demonstrating this...
Jason
